|
General Specifications:
|
|
Blade Size is an impressive 1" x .035" x 96.85"
|
|
Variable Blade Speed is 114' to 262'/min
|
|
Motor is 2HP
|
|
Measurements are 61"x29"x42" - Table Height is 35"
|
|
Weight is 620 lbs.
|
|
Broken Blade tension device shuts down machine if blade breaks.
|
|
Two cutting functions (manual or controlled descent)
|
|
Service Requirements: 220 Volt, 60Hz, Single Phase
|
|
|
|
Capacity:
|
|
Cutting Degree
|
90°
|
45°
|
60°
|
45° (L)
|
|
Round
|
9"
|
6"
|
3½"
|
4¼"
|
|
Square
|
8½"
|
5¾"
|
3-3/8"
|
4¼"
|
|
Rectangle
|
8" x 9-1/2"
|
5 1/2" x 6"
|
3-3/8" x 3-3/8"
|
6¼" x 4¼"
|
- Cast iron saw head provides rigidity and swivels in two directions (dual mitering), 0-60 degrees (R) and 0-45 degrees (L)
- Direct gear drive helps extend saw blade life, and allows saw head to make more accurate cuts and cut faster.
- Dual descent modes: 1 -Manual descent mode is operated by pulling down on handle and actuating trigger switch. 2- Hydraulic descent feed can be adjusted by operator.
- Powerful coolant pump cools blade, assists chip removal system, and extends blade life. We recommend using an petroleum based or synthetic based coolant that you would typically mix with a 1 to 10 ratio (coolant to water). This type of coolant can be purchased at any local industrial supplier.
- Broken blade tension devise shuts down machine if blade breaks.
The gear driven BS-260M is a 9" Band Saw and is the perfect saw for cutting at 90 degrees or miter angles. This saw has a dual angle head capable of cutting 0-60 degrees (R) and 0-45 (L), making it one of the most versatile saws on the market. Quick releases allow the operator to change the miter angle in seconds. Each gear driven metal cutting bandsaw we offer has variable speed, miter heads, and a hydraulic controlled descent devise for perfect feeds and longer blade life. This machine ships with a quality blade that is 97" long. It is recommened that you use quality saw blades purchased by reputable manufacturers like Lenox®, Starrett® or Wikus®. Our band saws are constructed of a heavy cast iron saw head and base and the blades are guided via a tungsten carbide insert offering rigidity and accuracy. Each band saw has a powerful coolant system and a broken blade tensioning devise that shuts down the machine if the blade breaks. This is the perfect bandsaw for cutting solids, tube or pipe, angle iron and much more. These mitering saws are great for cutting ferrous and non-ferrous metals such as aluminum, mild steel, stainless steel, chromoly or brass.
|
