|
|
General Specifications:
|
|
Capacity is 10 gauge mild steel or 14 gauge stainless steel
|
|
Strokes per min are 44-55
|
|
Hold downs included are 8 with 2.5 tons of pressure
|
|
Top blade has hydraulic adjustments for the rake angle
|
|
Top blade rake angle 1/2-2 degrees
|
|
Motor is 7.5 HP
|
|
Hydraulic Oil Capacity is 25 gallons
|
|
Weight is 3960 lbs
|
|
Packing size is 90” x 48” x 64”
|
|
Manual back gauge
|
|
Service requirement is 220 Volt, 3 Phase, 60 Hertz
|
The SH-5210HD hydraulic sheet metal cutting shear is a heavy duty machine built for years of production. This machine has thick steel plate frame that is electro welded and uses industrial grade hydraulics.
This hydraulic sheet metal cutting shear has a very rigid carriage that rides against hardened carriage ways. Heavy duty bearings are used to reduce friction and wear. The front side of the machine has a heavy duty load table and side gauges. At the rear of the machine is a manual back gauge.
The centralized control panel offers the selection of jog, single or continuous cutting modes. There is also a dial for adjusting the rake that eliminates curl and twist in cutting. The upper blade is two sided while the lower blade is four sided. The blades can be surface ground when dulling occurs for further blade life.
Like all Baileigh Industrial hydraulic sheet metal cutting shears, this one is built for decades of operation.
|
